Press TG on the main panel, then TG On in the soft keys, Normalize, Stor Ref, and Normalize On. Adjust resolution bandwidth to about 30 kHz, or so, for a better dynamic range. The Device to be measured will connect to the IN port of the coupler, but wait until after the normalization procedure to connect it.
DSA815 TEST HARMONICS MEASUREMENTS GENERATOR
Connect short coax cables between the CPL port to the DSA815 RF Input and the OUT port to the tracking generator Gen Output port. You’ll need a Mini-Circuits ZF-DC-5 20 dB coupler, or equivalent. All that’s required is to measure the return loss (in dB) and use that to calculate VSWR using Equation 1.įigure 1 – Measurement setup for return loss. This method is an alternative when the VSWR option is not included. If you don’t have this option, you can alternatively measure return loss (RL) using just the tracking generator feature. If you’ve also ordered the VSWR option, the measurement will read out VSWR directly. In order to use the Rigol DSA815 to make these measurements, it must have the tracking generator option.
This would usually be expressed as a VSWR of “1.3”. For example, an antenna may measure 1.3:1 at resonance.
DSA815 TEST HARMONICS MEASUREMENTS HOW TO
This article discusses how to use the Rigol DSA815 to make this measurement. For example, if an antenna measured a VSWR of 2:1 at a particular frequency, this could indicate an antenna impedance of either 100 or 25 Ohms (the impedance deviated from 50 Ohms by either twice or half).
It is generally expressed a a ratio of the measured impedance to 50 Ohms. Voltage Standing Wave Ratio (VSWR) is a measurement of the impedance match of any RF component, subassembly, instrument in reference to a standard 50-Ohm resistive impedance.
0 kommentar(er)
